ok i just installed a light flywheel and 6 puk clutch i have bled the **** outta the slave and ajusted the pedal both ways and the clutch still slips help please oh and yes i did spray the flywheel down with brake cleaner...

 

it slips to the point that if i give it any gas a little above idle all it does is slip...?

 

did you put on a new pressure plate?

what clutch did you buy? brand,?

 

yea its a spec clutch and pressure plate flywheel is a exedy

 

how different is a turbo clutch disc than a na disc im juts ruling out possable problems and what about the aftermarket flywheel

 

you might of contaminated the clutch with something

 

if you accidentally got a turbo II clutch disc, the hole with the splines is a hair bigger because i belive it has a 1 spline more than n/a. you probably would have noticed play while installing it though. Plus i think the disc is 1/2" bigger overall.


Make sure your pedal is adjusted also.

 

when you installed the clutch did you make sure to have it facing the proper way? ie the side that says flywheel towards the flywheel. also did you have to use a counter weight with this install? just wondering because i had to when i installed my rd aluminum flywheel and spec clutch.

 

That's true, did you buy a counter weight for the flywheel? If so, then did you clean the clutch, pressure plate, and flywheel up good?

 

Yes it is installed the right way the only thing I didn't do that tall have said I didn't spray down the pressure plate but I did spray down the flywheel should I tear it all back down and give it all a good bath in brake parts cleaner

 

Oh and yes I got. Counter weight I got it from an automatic car I think it came off of a 91 I know the counter weight is right cause the car revs smooth real smooth and it all fits right.....

 

The pressure plate will also come covered in oil, your clutch disk is contaminated.

Take it out and clean everything very thoroughly.

 

Yea that's what I figured I will post again to let you know if doin that fixes it I'm shure I will thanks so much for all the help