Need to replace some parts...
#4
anyways
i didn't glance at the FSM
I was trying to remove the plastic cover off the fan and battery base.
While trying to move it, I took this cap off the radiator and the wire snapped.....what is it and where can I get a replacement for it?
Also the screws/bolts by the radiator cap is rusted, they won't budge...how am I to get those off?
Reminder, I lack a full tool set, money and uh....jeez I just have a few wrenches and what not.
i didn't glance at the FSM
I was trying to remove the plastic cover off the fan and battery base.
While trying to move it, I took this cap off the radiator and the wire snapped.....what is it and where can I get a replacement for it?
Also the screws/bolts by the radiator cap is rusted, they won't budge...how am I to get those off?
Reminder, I lack a full tool set, money and uh....jeez I just have a few wrenches and what not.
#7
LS what?
iTrader: (3)
Join Date: Aug 2001
Location: Raleigh, NC
Posts: 1,180
Likes: 0
Received 0 Likes
on
0 Posts
You need to get a Haynes manual or factory service manual before you start tearing stuff apart. The wire that snapped is your coolant level sensor. Try to resolder it. If that can't be done look in the 'parts for sale' section, you should be able to find one for cheap. If not, go to the dealer. To get the car started, turn the steering wheel to the left or right a little, then try to turn the key.
The best advice I have is to do your research and figure out what you are doing beforehand and get some decent tools so you can do it right. Also use the search button, you can find a lot of good information that way.
The best advice I have is to do your research and figure out what you are doing beforehand and get some decent tools so you can do it right. Also use the search button, you can find a lot of good information that way.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM