need a new motor rear rotor dead have a s4 tii want to rebuild it with 3mm seals and street ported any suggestions on where to go and anyone running this setup who did it and how dose it run

 

3MM seals are not necessary unless you rotors are too worn to accept 2MM seals.

If you do a search on "rebuild", you will find lots of info.

 

For a rebuilder, check the SE RX-7 section, I belive FL is the state with more rotary engine builder\tuners per population

 

For a rebuild:

http://www.atkinsrotary.com
http://www.rotaryresurrection.com
http://www.speedmachineperformance.com

Just a few I'm sure you can search and find so many more. Or better yet, do it yourself. You'll learn alot of a valuble lesson about your car.

 

kevin landers and dan atkins (rotary resurrection, atkins rotary) have always treated me awesome

 

Kevin's a great guy. Even when you're not a customer he's always there to help you and give you suggestions. Plus his work is top notch and he has a warranty for them now.

 

Lowes Auto performance is in FL too.
He rebuilt and ported my engine...wondefull job.

 

Kevin even helps poor people like me do it myself, when I can't afford to pay him to rebuild it... although now that it's pretty much over, I bet it would've been cheaper to have him do it, just that doing it myself spread the cost over 3 months (DOH) lol.

Go to Kevin!

--Gary

 

Yep, he helped me with my first rebuild too. Great guy.

Hopefully I'll be bringing him an FD engine for a rebuild and port in the near future if all goes well.