Need help with wiring. Feel free to flame
06-22-11, 07:21 PM
#1
Rotary Enthusiast
Thread Starter
Need help with wiring. Feel free to flame
Ok a few month ago I decided to pull the motor on my 87 TII. Well for some reason I didnt mark all the wiring, 
so now there are about 8 plugs i cannot figure out where they go. I have searched and searched the FSM but no luck. So post what i need one at a time on here i did get some pics. Feel free to flame cause of my dumba$$ mistake. but leave help after words
.
The 1st wire i need help finding is the oil thermo wire. It goes into the oil pan but i cannot figure out where it plugs into on the harness. I checked FSM but i couldnt find it in there.. All i can find is the oil level sensor which I have plugged in. thanks for the help
EDIT: i read that the oil thermo is for cold start assist which i removed.
now i need help identifying the black plug in the center
so now there are about 8 plugs i cannot figure out where they go. I have searched and searched the FSM but no luck. So post what i need one at a time on here i did get some pics. Feel free to flame cause of my dumba$$ mistake. but leave help after words. The 1st wire i need help finding is the oil thermo wire. It goes into the oil pan but i cannot figure out where it plugs into on the harness. I checked FSM but i couldnt find it in there.. All i can find is the oil level sensor which I have plugged in. thanks for the help
EDIT: i read that the oil thermo is for cold start assist which i removed.
now i need help identifying the black plug in the center
Last edited by florotory; 06-22-11 at 07:46 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM