overpaid4myfc

iTrader: (14)

So I just got an 87 TII and the guy who had it before me swapped in the manual regulators and door panels and all that jazz and even managed to hack up the door harness for no reason. So I got the power window switches, door panels and regulators from a 10th AE. I put it all in and put in new door harnesses and the whole 9. The drivers window rolled down when I plugged in the harness, the passengers didn't. On the passenger side door harness there are 2 big plugs and 1 smaller 2 prong plug. On my car I can't find the 2 prong connector for the one that mates with the door harness plug. I know that plug is for the window motor.

I checked my 87 NA and my 10th AE and they both have the plugs on the body harness I'm looking for. So I thought the tool that hacked up the door harnesses might have cut the plug off the body harness so I cut back some of the electrical tape as far back as I could and I can't find the little red and green wires for the plug and it's starting to look like my car never had the plug I'm looking for.

I'm so lost

satch

iTrader: (1)

The plug that goes to the passenger window should has 5 wires to it. The Red wire and the Green wire goes from the switch to the motor. The Red/White wire and the Green/White wires run from the switch to the door harness. The passenger door harness should have 7 wires. The only two wires you need from the driver switch connector, Dr-09 having 7 wires that goes to the passenger door harness, which has 7 wires is the R/W wire and the G/W wire.

overpaid4myfc

iTrader: (14)

Well everything is plugged in on the door itself, the switch and motor etc. I know the motors are good cause I could jump them up and down. The only thing I'm not getting is why my car doesn't have the green/red plug on the cars harness? I dunno maybe my switches are bad but the guy that I got them from on here said they're good.