So I have a new na motor in my rx7 and everyone is telling me its not possible to turbo it. I think it can be done. So I need some help or pointers on what I need to buy to do this and how to make this happen. Or how much boost can I run on this? To start off I have a stock turbo 2 intake manifold, Lower turbo intake manifold and Turbo. I also have a 3' inch piping and a downpipe set up on my car already so i need to know can I jsut bolt this up or what else would i need to finish this can someone Help?

 

https://www.rx7club.com/2nd-generation-specific-1986-1992-17/possible-change-s4-t2-lim-uim-into-s4-n-619014/

Start reading up. Searching. Reading. Searching. Reading.

http://forum.teamfc3s.org/showthread.php?t=37694

I searched and read these two forums for weeks before I even started to work on my Turbo 6 port.

 

http://www.aaroncake.net/RX-7/

 

Dude your awesome thanks for the great links i defenitely will look into it more after looking at this. I thank you for the advice.

 

Well that's because the turbo motor very different from the NA motor.

Check the FAQ:
https://www.rx7club.com/2nd-generation-specific-1986-1992-17/frequently-asked-questions-2nd-generation-rx-7-faq-fc-494667/

and more specifically...

The (Almost) Complete Guide To Turbocharging The Naturally Aspirated Second Generation RX-7
http://www.aaroncake.net/rx-7/naturbo.htm

 

You two raptor 22 thanks its kind of hard finding people in Vegas that actually now what they are doing or even talking about when it comes to rotaries in Vegas let alone work on them thanks for the help.

 

http://forum.teamfc3s.org/showthread.php?t=37694