need help plz. after injector rebuilt,car run bad
need help plz. after injector rebuilt,car run bad
first hi to every one there.2 sry for my bad english.
ok this winter i puted out injector for test flow,after rebuilt i put it back.
(whit the hayness manual instruction)
after that, i drive the car 1 or 2 time and no problem at all.
but after, engine lack power when i hit the gaz pedal.
the engine rpm go to 1.5rpm and drop every time.
the afm was ok,the gasket on lower and top manifold was new.
new o ring to, gaz tank full, all hose and wiring conected.
today i will check the fuel filter(1 years on it but..)
help will be very apreciate
thx dan
ok this winter i puted out injector for test flow,after rebuilt i put it back.
(whit the hayness manual instruction)
after that, i drive the car 1 or 2 time and no problem at all.
but after, engine lack power when i hit the gaz pedal.
the engine rpm go to 1.5rpm and drop every time.
the afm was ok,the gasket on lower and top manifold was new.
new o ring to, gaz tank full, all hose and wiring conected.
today i will check the fuel filter(1 years on it but..)
help will be very apreciate
thx dan
I had a similar problem when i put in some injectors that were cleaned and balanced. The car ran fine for a few minutes then the car would not want to start. My idle was really bad, the car had no power. My problem was that one of the injectors were stuck closed for some reason. But the injector fixed itself and the car ran normal after that.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM



