need cluch help
#1
Junior Member
Thread Starter
Join Date: Aug 2004
Location: georgia
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
need cluch help
hi,i'm new to and this is my first post.i just got a '86 rx-7 form this guy in Ga. ,anyway i drive it from there to Louisiana where i live.everything was fine but now i can't get it to go into gear,and the cluch petal feel soft when i press it and the petal doesn't return.also it grinds when i try to put it into gear and it will not go into gear.does anyone know what what could be wrong.thanks in advance
#2
Rotarys=Male Enhancement
Join Date: Oct 2003
Location: Indy, IN
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
Could be anything from a bad Slave or Master Cylinder or a throw-out Bearing or it even may just need bled.
My first thought is check the clutch fluid, if its full (or empty)try bleeding the clutch (after you put fluid in if its empty of course) and see what it does. If you bleed it and it is still very soft i would try replacing the Slave cylinder....I had the exact same thing happen in my old TII and the Slave cylinder was the culprit.
My first thought is check the clutch fluid, if its full (or empty)try bleeding the clutch (after you put fluid in if its empty of course) and see what it does. If you bleed it and it is still very soft i would try replacing the Slave cylinder....I had the exact same thing happen in my old TII and the Slave cylinder was the culprit.
Thread
Thread Starter
Forum
Replies
Last Post