2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

Need advice please

Thread Tools
 
Search this Thread
 
Old 05-19-11, 01:29 PM
  #1  
Full Member

Thread Starter
iTrader: (2)
 
hvaltierra's Avatar
 
Join Date: Jun 2005
Location: Arcadia, Ca
Posts: 124
Likes: 0
Received 3 Likes on 3 Posts
Need advice please

So I think I blew a seal. Full exhaust dp back(mindtrain). Cone filter are the mods. Had but 87 on accident over boosted fuel cut kicked in heard a ping ping. So the reason im queastioning a seal is beacuse it has full power drives fine but has a rough idle. no smoke at start up or otherwise oil temp is normal water temp is.normal.
Old 05-19-11, 05:21 PM
  #2  
Registered Loser

iTrader: (6)
 
walken's Avatar
 
Join Date: Dec 2002
Location: Whiterock
Posts: 2,224
Likes: 0
Received 0 Likes on 0 Posts


do a compression check to make sure. if that's fine you might have just popped a vacuum hose.
Old 05-22-11, 01:17 PM
  #3  
Full Member

Thread Starter
iTrader: (2)
 
hvaltierra's Avatar
 
Join Date: Jun 2005
Location: Arcadia, Ca
Posts: 124
Likes: 0
Received 3 Likes on 3 Posts
Ok did a compression test I got 100psi on the front rotor and 75psi on the rear rotor. What's normal? I just found a motec printout that the previous owner had done aug of 2010 they were reading 103.7 on the front and 104.1 in the rear.
Old 05-22-11, 01:46 PM
  #4  
Rotary Enthusiast

 
jerd_hambone's Avatar
 
Join Date: Jan 2005
Location: Good Ol' Ky
Posts: 1,482
Likes: 0
Received 0 Likes on 0 Posts
Thats pretty low on the rear.... Not sure if my memory is right, but somewhere around 95+ is where you want to be.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Andrew7dg
1st Generation Specific (1979-1985)
3
08-06-17 01:41 PM
eddierotary
Engine Management Forum
16
10-04-16 08:22 PM
Zinraf
2nd Generation Specific (1986-1992)
3
10-01-15 01:09 PM
izzolaw
1st Gen General Discussion
2
09-27-15 08:33 PM
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM



Quick Reply: Need advice please



All times are GMT -5. The time now is 05:44 AM.