RX7Club.com - Mazda RX7 Forum

2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:
Banzai Racing

Narrowband settings in a wideband software

Thread Tools
 
Search this Thread
 
Old 03-05-08, 12:36 PM
  #1  
FKITALL

Thread Starter
iTrader: (14)
 
The Wankler's Avatar
 
Join Date: May 2004
Location: Dublin Ca.
Posts: 3,589
Likes: 0
Received 2 Likes on 2 Posts
Narrowband settings in a wideband software
I was wondering what the correct settings are. The settings in the pic below do not seem right to me.
Thanks,
Chris
Attached Thumbnails Narrowband settings in a wideband software-wideband.jpg  
The Wankler is offline  
Reply Like
Old 03-05-08, 12:50 PM
  #2  
The Silent but Deadly Mod

iTrader: (2)
 
Roen's Avatar
 
Join Date: Aug 2003
Location: NYC/T.O.
Posts: 4,047
Received 3 Likes on 3 Posts
That looks exactly like how a stock narrowband works.
Roen is offline  
Reply Like
Old 03-05-08, 12:57 PM
  #3  
FKITALL

Thread Starter
iTrader: (14)
 
The Wankler's Avatar
 
Join Date: May 2004
Location: Dublin Ca.
Posts: 3,589
Likes: 0
Received 2 Likes on 2 Posts
ok, thank you!
The Wankler is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Installed UIM gasket, now my engine won't run
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Microtech Newbie Microtech tuning tips
stickmantijuana
Microtech
30
04-23-16 06:37 PM
AEM Tuning actual load/boost problem on the main map.
sen2two
AEM EMS
9
10-23-15 07:51 PM
Rtek how to calibrate sensor into plviewer?
tidanb0utch
Rtek Forum
0
08-25-15 05:55 PM
Back to Subforum
2nd Generation Specific (1986-1992)
View Next Unread
Bad clutch switch? idle surges




Advanced Search
Quick Reply: Narrowband settings in a wideband software


Reply Closed Thread Share

All times are GMT -5. The time now is 03:58 AM.