Na S5 engine harness on a s5 turbo II engine
#1
Senior Member
Thread Starter
iTrader: (7)
Join Date: Jul 2008
Location: ohio
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
Na S5 engine harness on a s5 turbo II engine
I am almost done with my 87 rx7 that I did a s5 turbo II swap into. I am using a haltech E8 stand alone with the plug and play patch. I started hooking up the s5 NA engine wiring harness to my s5 turbo II motor and everything lines up on conecters but the only two I can't figure out is the 02 sensor and the tps because the tps is differnt for the turbo II throttle body. All I need to Know for the 02 sensor is what the wire color is and what the plug looks like. And for the tps I need to know how to wire that up.
#2
Top Down, Boost Up
iTrader: (7)
O2 sensor wire color is in the S5 wiring diagrams (https://www.rx7club.com/2nd-generation-rx-7-1986-1992-vehicles-108/1989-s5-t2-black-roller-clean-title-916244/#post10147108).
The TPS is exactly the same, so there is nothing you should be doing except probably extending the wires.
The TPS is exactly the same, so there is nothing you should be doing except probably extending the wires.
#4
Senior Member
Thread Starter
iTrader: (7)
Join Date: Jul 2008
Location: ohio
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
I forgot to say that there is some wire cut and it looks like there may have been a conector there. It's right next to the passenger side strut tower. I really need a picture of a tps conector on a s5 na engine wiring harness. So I know were it is located at.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM