n333 vs n338
03-19-13, 07:49 PM
#26
Turbo2ltr from Pocketlogger (Rtek) had this to say about the N338 ECU in the Rtek FAQ thread:
https://www.rx7club.com/rtek-forum-1.../#post10530365
The only other info I've found on using the ECU in a TII has been rumors with no proof to back it up. Info from Pocketlogger has always been good since they reprogram the ECUs and are familiar with the way they handle inputs/outputs.
https://www.rx7club.com/rtek-forum-1.../#post10530365
Originally Posted by turbo2ltr
If it's an N338, the S4NA Rtek should work fine. I can't say I've done a whole lot of them. Searching back my emails, I see two people since 2003 asking about it.
Our research shows that the N338 is basically the same as an N326/N327. Contrary to popular believe it will not run a Turbo motor any better than an N326/327.
Our research shows that the N338 is basically the same as an N326/N327. Contrary to popular believe it will not run a Turbo motor any better than an N326/327.
Thread
Thread Starter
Forum
Replies
Last Post
