im going to buy a jdm turbo motor from a well known guy on the site. my car is an n/a what am i going to need to hook this motor up? please fill me in. thanks

 

alot of things, at least, ( if you get a engine of the same series, if s4 stick with s4, ect)

a good fuel pump, turbo ecu, turbo afm, turbo boost sensor, turbo hood, ( or a front mount ie expensive) , turbo ehxuast, then u will have to modifiy your na wiring harness a bit( extend several wires, then remove a few), then install the NA flywheel and clutch, then u can reuse your na drive train


OR a more expensive method would be to get a whole t2 drive train, trany driveline rear diff and half shafts, and it would be alot stronger than the NA stuff.

OR find t2 pass and driver side wiring harness, again expensive

 

This has never been asked, or even thought of, before. Congrats, you are the first.

^ Teh winnar!



http://www.rotaryresurrection.com/2n...to_turbo2.html

http://www.rotaryresurrection.com/2n...in_differ.html

 

Please check the FAQ. This is the most common question asked on this forum and is well documented.

Closing thread.