2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

My ECU is toast (pics)

Thread Tools
 
Search this Thread
 
Old 07-26-03, 07:06 PM
  #1  
Open up! Search Warrant!

Thread Starter
 
Project84's Avatar
 
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes on 2 Posts
My ECU is toast (pics)

I have been having trouble with my car. I did some research and trouble shooting and even some and couldn't come up with an explanation. I took the ECU out and opened it up. I noticed the burnt, melted solder on the back of the circuit card, and when I turned it over I saw that one of the blue resistors is not brown and blue.


Last edited by Project84; 07-26-03 at 07:34 PM.
Old 07-26-03, 07:13 PM
  #2  
Open up! Search Warrant!

Thread Starter
 
Project84's Avatar
 
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes on 2 Posts
Here is the other side

Last edited by Project84; 07-26-03 at 07:33 PM.
Old 07-26-03, 07:13 PM
  #3  
Open up! Search Warrant!

Thread Starter
 
Project84's Avatar
 
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes on 2 Posts
stupid double post. And why is this forum so ******* slow

Last edited by Project84; 07-26-03 at 07:16 PM.
Old 07-26-03, 07:48 PM
  #4  
Senior Member

 
krazydru784's Avatar
 
Join Date: Jan 2003
Location: so cal
Posts: 295
Likes: 0
Received 0 Likes on 0 Posts
what problems were u having?
Old 07-26-03, 08:55 PM
  #5  
Open up! Search Warrant!

Thread Starter
 
Project84's Avatar
 
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes on 2 Posts
car will start and idle, but if I press the gas pedal, it will not rev up. YES the throttle cable is hooked up.
Old 11-12-03, 12:30 PM
  #6  
Like Ghandi with a gun

 
Kenteth's Avatar
 
Join Date: Mar 2003
Location: Rapid City, SD
Posts: 4,584
Likes: 0
Received 0 Likes on 0 Posts
so thats why you got that haltech
Old 11-12-03, 01:32 PM
  #7  
HAILERS

 
HAILERS's Avatar
 
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes on 19 Posts
Oh. I've had that problem. Drove the car to the store. Came out of the store to go home. Car started. Pressed the pedal. No reaction. Looked and saw the cable had not fallen off. Puzzled. Pulled the tps plug apart. Drove home. TPS was stuck/broken.....cause the fuel to be cut off when moved.

Put it all back together. Do as above...except you don't have to drive to the store. Just pull the tps plug APART.
Old 11-12-03, 01:34 PM
  #8  
HAILERS

 
HAILERS's Avatar
 
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes on 19 Posts
And the lack of blueness on the resistor might mean/not mean something. It could just be related to something like the output to the Relief or Switching solenoid, something one would not notice in daily driving.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Daua118
SE RX-7 Forum
25
12-05-21 04:15 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
zuesskroph
2nd Generation Specific (1986-1992)
0
08-13-15 06:05 PM



Quick Reply: My ECU is toast (pics)



All times are GMT -5. The time now is 04:05 AM.