Is my BAC Valve bad?
08-29-06, 08:47 PM
#1
Is my BAC Valve bad?
ok well today after i set the timing the idle was high so i went to the bac valve to adjust it and it wont go below like 1 grand, well just curious i unpluged the bac valve and the cars idle didnt move. So i cut the car off and tested resistance across the terminals and it was like 13.5. Does that mean that i need another bac valve. If so where can i get one that works and is within specs. How much is a new one???? Thanx.....
08-29-06, 09:06 PM
#2
Rotary Enthusiast
do you have emissions. what i did was i took off the BAC and i blocked it off. also try adjusting the idle screw on top the the Throttle body. right now my car idles at 1300rpms but it also modded
08-29-06, 09:51 PM
#4
Driving RX7's since 1979
iTrader: (43)
Join Date: Aug 2001
Location: So Cal where the OC/LA/SB counties meet
Posts: 6,096
Likes: 0
Received 8 Likes
on
8 Posts
I'm very interested in this one as well. I have full emmissions in my TII Vert, but I can't get my idle to drop below about 1,200 once fully warm (unless I turn on the AC).
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM