motor swap driving problems
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jul 2003
Location: milpitas, CA
Posts: 1,133
Likes: 0
Received 0 Likes
on
0 Posts
motor swap driving problems
i just put in a rebuilt motor, got it to start-up. idles, i can rev up during idle. when i let go of clutch, it car grabs and rolls, but i cant gas as the car to get it moving, if i let go of clutch too much car stalls, why cant i gas while clutching out?!?!!
thanks
eric.
thanks
eric.
#2
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jul 2003
Location: milpitas, CA
Posts: 1,133
Likes: 0
Received 0 Likes
on
0 Posts
another problem other than the fact that i cant gas the car while the clutch is out.
my temperature gauge doesnt work anymore, the car was on for about 10-15 mins and still the temp gauges sits at the bottom
elaborate on the other problem, when the clutch is out i can press teh gas peddle down but nothing happens, no change in rpm car wont move forward, nothing happens! but when im in neutral or clutch is down, and i press on teh gas peddle i am able to raise the rpm
so confused!
eric.
my temperature gauge doesnt work anymore, the car was on for about 10-15 mins and still the temp gauges sits at the bottom
elaborate on the other problem, when the clutch is out i can press teh gas peddle down but nothing happens, no change in rpm car wont move forward, nothing happens! but when im in neutral or clutch is down, and i press on teh gas peddle i am able to raise the rpm
so confused!
eric.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
82streetracer
Haltech Forum
11
03-11-19 05:34 PM