mop block off question
Thread Starter
Joined: May 2001
Posts: 2,390
Likes: 2
From: San Francisco, CA
mop block off question
I'm running premix and the front cover (series 5) still has the shaft assembly in it and I have the block off plate. My question is can I machine a piece of aluminum or even easier, stack several dimes or washers in there to keep the shaft from sliding back and forth after the plate has been installed or does the shaft and/or the entire assembly have to come out?
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM