MOFO window!
Joined: Jun 2006
Posts: 4,815
Likes: 24
From: Columbia, Tennessee
To figure out if the motor is good take the cable that goes to the door light and plug it into the motor connector. It should go down. Reverse the wires to make it go back up. If it works then you'll need to either clean the inside of the switches, check to make sure the wiring is complete, or make a whole new switch setup.
I had this problem with both windows
So I got 2 new doors(my old doors were in bad condition)
after installing and taking them off twice I found out that it was just the switch on the interior panel ^_^
so go to a junkyard and try getting new switch
So I got 2 new doors(my old doors were in bad condition)
after installing and taking them off twice I found out that it was just the switch on the interior panel ^_^
so go to a junkyard and try getting new switch
Thread
Thread Starter
Forum
Replies
Last Post



