illtakeyochik

If i am using the x4 with the lt10s, do i still need to wire up the ignition part of the lt10s?? and if i do, how???

oh and i am using MSD coils..

and how do i run the vaccume lines from:
1. The wastegate??
2. The Turbo ??
3. The 3 bar map sensor???
4. The Microtech??
5. The boost gauge???
__________________

illtakeyochik

h and how do i run the tachometer line from the microtech??
and i also need help running my ignition switch line???

Thank You guys!!

2-N-D-pink

iTrader: (27)

Oh my god dude, if you dont know how to run vacuum lines to a boost gausge from the intake manifold....and you wanna install a mirotech, your better off letting some one else do it. It'll save you a bunch of trouble because I can guarantee you'll run into problems after you wire it all up. And whats gonna be worst is, tracking where you did something wrong. Apparently vacuum lines is hard for you to do. Tracking something that isnt working is gonna be hell.

HAILERS

If I were you, I'd also ask this question in the following forum: https://www.rx7club.com/forumdisplay...ysprune=&f=111

Seems to me you'd get a faster response there.

Did you get a manual with that outfit? Has some instructions? Have you looked for a MicroTech forum online? Other than this one? It seems they (MicroTech) would have a online help forum of their own.

Just some suggestions. I could care less if you ask on this site one way or the other. It just seems there are alternative places to look that Might be better. Maybe not.

http://microtechefi.com/

https://www.rx7club.com/microtech-111/microtech-lt8-vs-lt10-748626/#post8156347

http://www.microtechusa.com/wiring.html

illtakeyochik

yea it came with a manual... but the manual does not get into the X4 ignition box. and it does not explain the soil settup very much at all either...

i know how to run the vaccume line i just wanted to be sure of them.. because im goin to have quite a few.. thanks anyway

HAILERS

The guy called rx72c in the link I gave above seems to know about the X4 and LT10 units. In fact he mentions how to wire the X4 in post number #11 of that post above. The post number is in the upper right hand corner of each thread. In other words the eleventh reply to that thread.

If nobody gives you a resonable answer in the next few days, try PMing the rx72c guy.

illtakeyochik

thanks man i appreciate it..