metric redaing
#1
Senior Member
Thread Starter
Join Date: Dec 2001
Location: WEST
Posts: 354
Likes: 0
Received 0 Likes
on
0 Posts
metric redaing
Does anybody know the metric vacuum conversion to inches?
I forgot what the formula was. As you all know the Japan boost/vacuum gauge are all in metric .
I forgot what the formula was. As you all know the Japan boost/vacuum gauge are all in metric .
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
This thread and answer by *IRV* http://www.rx7forum.com/showthread.p...threadid=16779
#5
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
1cm = .3937in and http://www.flowmeter-calibration.com....html#pressure and put 300 where it says mm/hg and get 11.81 in/hg. And I just noticed if you use that conversion table and put in say 300mm/hg and hit *convert*, that over there on the far left where it says *psi*, that it reads 5.8 which coincides with Irv's table. We're double checking your figures, Irv!
Last edited by HAILERS; 12-23-01 at 05:08 AM.
#7
Lives on the Forum
Originally posted by IWNTA20B
Ahh....cool. Thanks Hailers.
Ahh....cool. Thanks Hailers.
Most Japan gauges run kg/mm^2 in boost.  To convert to psi, multiply by 14.2 - 1.0kg/.mm^2 = 14.2psi.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM