MAP sensor voltage range S5 TII
11-16-07, 08:42 PM
#1
Full Member
Thread Starter
iTrader: (4)
Join Date: Sep 2005
Location: LA
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
MAP sensor voltage range S5 TII
Hi, I would want to know if stock MAP sensor from a S5 TII runs from 0 to 5V. I am asking this for getting a 3D mappable water injection.
Another question: if I take the rpm signal from the ecu, how must I set the cylinder number, 2 or 4?
Kindest regards
-Javier
Another question: if I take the rpm signal from the ecu, how must I set the cylinder number, 2 or 4?
Kindest regards
-Javier
11-17-07, 05:25 AM
#3
Full Member
Thread Starter
iTrader: (4)
Join Date: Sep 2005
Location: LA
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
Thanks a lot.
Question about FPR vacuum lines: I noticed that two vacuum lines arrived to my FPR instead of only one, I am wondering which is the target of the second onethat is between fuel and the other vacuum line because I am thinking in going directly only with one vacuum line instead of by the FPR solenoid with these two lines.
Thanks one more time
Question about FPR vacuum lines: I noticed that two vacuum lines arrived to my FPR instead of only one, I am wondering which is the target of the second onethat is between fuel and the other vacuum line because I am thinking in going directly only with one vacuum line instead of by the FPR solenoid with these two lines.
Thanks one more time
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
08-22-15 05:52 PM
