Mallory 6A wiring question
02-18-06, 10:58 PM
#1
ROTARY AUCTIONS
Thread Starter
Join Date: Jan 2005
Location: Texas
Posts: 314
Likes: 0
Received 0 Likes
on
0 Posts
Mallory 6A wiring question
On my leading coil there are 4 wires. But in the following Diagram there are 5 wires. So my question is what wire is not needed?
The diagram Shows the amp having a IGN, +, and -. Is the white wire not needed?
The diagram Shows the amp having a IGN, +, and -. Is the white wire not needed?
02-18-06, 11:21 PM
#2
Former Moderator. RIP Icemark.
http://www.fc3spro.com/TECH/HOWTO/CDI/cdi.html
yellow and green and purple are not used.
Yes, you must use the white wire... it goes to the ignitor side of the (-) coil wire that you cut.
yellow and green and purple are not used.
Yes, you must use the white wire... it goes to the ignitor side of the (-) coil wire that you cut.
02-18-06, 11:51 PM
#3
ROTARY AUCTIONS
Thread Starter
Join Date: Jan 2005
Location: Texas
Posts: 314
Likes: 0
Received 0 Likes
on
0 Posts
So the wire that say "TO IGNITION SWITCH", does not exist on our cars?
I'm also installing a micro-tech. Where does the ignition output wire-up to? Its only one wire, and I believe that its a trigger wire.
I'm also installing a micro-tech. Where does the ignition output wire-up to? Its only one wire, and I believe that its a trigger wire.
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM