machine stock flywheel?
05-30-03, 01:58 PM
#1
Hks Ownz Me (
Thread Starter
Join Date: Dec 2001
Location: corona,CA
Posts: 1,489
Likes: 0
Received 0 Likes
on
0 Posts
machine stock flywheel?
would it be safe machining a few pounds off your stock flywheel say like.... 5 -6 lbs? if so where could you get it done at? thanks
05-30-03, 06:05 PM
#3
Displacement > Boost
Join Date: Oct 2002
Location: Mississippi
Posts: 3,503
Likes: 0
Received 0 Likes
on
0 Posts
Hmmm . . I have thought about this. The problem would be the counterweight that is cast into it. I guess you could get a shop to turn the front face on a lathe. I think the stock flywheels are cast iron which may not work in a thin flywheel like steel or aluminum, but you could always take it to a machine shop and ask them if they could do it.
Thread
Thread Starter
Forum
Replies
Last Post
Claudio RX-7
Haltech Forum
5
04-23-19 02:50 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM