ls1 coils
#5
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
You should actually look at these.
Mercury Marine IGN-1A Smart Coil
Side note: I went to check spark(blew engine recently) and accidentally lifted the wire up and "WAAAAAAAAHHHHH"..lol.!.
they work real GOOD!
Mercury Marine IGN-1A Smart Coil
Side note: I went to check spark(blew engine recently) and accidentally lifted the wire up and "WAAAAAAAAHHHHH"..lol.!.
they work real GOOD!
#6
destroy, rebuild, repeat
iTrader: (1)
the cheap ones like the d577 do not have a built-in ignitor, so you would have to run an external ignitor. the one agreen linked to do have built-in ignitor, so more pricey. i would recommend sticking to the factory coils, they are optimum for rotary chamber, i would only upgrade if having misfire problems due to a lot of boost or use of anti-det injection
if you really must run aftermarket, go with IGN-1A coils. whatever you do, do not use LS2 truck style (D858), worst of the LS bunch
if you really must run aftermarket, go with IGN-1A coils. whatever you do, do not use LS2 truck style (D858), worst of the LS bunch
Trending Topics
#8
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I am running the PS1000 also,and the IGN-1A's...and my ignition is great now.
I had the old CAS,stock leading coil and dual (FC Banzai) Trailing setup.It just didn't cut it.
NOTE:IF you change to the IGN setup from stock, when changing settings,make sure your coils are Disconnected.
Do not change the setup,turn the ecu on and then start configuring.
The L2 coil will fry if you do not have the coils disconnected....trust me..brand new coil..with GOOO coming out of it..ah Fark..
I had the old CAS,stock leading coil and dual (FC Banzai) Trailing setup.It just didn't cut it.
NOTE:IF you change to the IGN setup from stock, when changing settings,make sure your coils are Disconnected.
Do not change the setup,turn the ecu on and then start configuring.
The L2 coil will fry if you do not have the coils disconnected....trust me..brand new coil..with GOOO coming out of it..ah Fark..
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
3
09-28-15 09:25 PM
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM