Lots of fuel questions.
#1
Rotary Enthusiast
Thread Starter
Join Date: Apr 2001
Location: Mississauga
Posts: 974
Likes: 0
Received 0 Likes
on
0 Posts
Lots of fuel questions.
I am putting a TII motor in an NA. I will have a 3"dp/mp, 2.5" single, staightthru catback. Also the TID mod and FCD.
What do i need for fuel? Is a walbro enough?
My NA doesnt have the TII resistor pack, should i go with a rising rate fuel press. regulator or get the resistor pack?
An FCD gives enugh fuel for ~8psi, right? So will a rising rate fpr make it safer to run with an fcd, since it will increase pressure with boost.
What do i need for fuel? Is a walbro enough?
My NA doesnt have the TII resistor pack, should i go with a rising rate fuel press. regulator or get the resistor pack?
An FCD gives enugh fuel for ~8psi, right? So will a rising rate fpr make it safer to run with an fcd, since it will increase pressure with boost.
#3
Former Rx7 *****
Join Date: Nov 2001
Location: Mississauga
Posts: 4,534
Likes: 0
Received 0 Likes
on
0 Posts
I think you need the resisor pack inorder to run the injectors from the TII engine...
walbro should be fine... if you are worried about boost creep you can always pull the turbo off and port the wastegate some more... what TII engine is that? S4? or S5 TII engine?
walbro should be fine... if you are worried about boost creep you can always pull the turbo off and port the wastegate some more... what TII engine is that? S4? or S5 TII engine?
Thread
Thread Starter
Forum
Replies
Last Post
turbo-minivan
General Rotary Tech Support
69
02-04-16 12:29 AM
driftfcbuckey
The Bad & Fugly Members
10
12-02-15 05:48 PM