I did a search and found alot of N/A Pics .. but I didn't run into any good TII intake pics. I am in the process of cutting and fitting my piping and such .. for a eventual cold air intake box. A few pictures would be quite helpfull.

Links would be fine also.
Thx

 

http://hypntyz.rx7life.com/myturboII

 

What did you make those block off plates out of Kevin? How did you cut them?

 

1/8" sheet aluminum plate...cut with a diegrinder/cutoff tool, thus the poor angle smoothing.

 

what intake is that hypntyz?

 

Home depot racing...

 

You think I could whip something up like that with a dremel tool Kevin?

 

Yeah, except dremel tool cuttoff bits suck *** and it would take a lot of them in order to make the cuts.