2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

lights don't turn on

Thread Tools
 
Search this Thread
 
Old 11-17-03, 01:11 AM
  #1  
Senior Member

Thread Starter
 
rx78788's Avatar
 
Join Date: Nov 2003
Location: walla walla washington
Posts: 369
Likes: 0
Received 0 Likes on 0 Posts
Question lights don't turn on

hi I was just wondering if any one can help me out. my headlights will not turn on, the lights fold up but the lights wont come on. the headlights are good i have tested them but there is no power to them. I've tried putting a new switch for the head lights and the problem is still their. Can some help me I can drive my car past dark. thanks
Old 11-17-03, 07:00 AM
  #2  
Open up! Search Warrant!

 
Project84's Avatar
 
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes on 2 Posts
You try checking the fuse in the fuse box under the hood? There is one for the lights to come up and and down, and another to make the lights turn on and off.
Old 12-01-03, 12:51 AM
  #3  
Senior Member

Thread Starter
 
rx78788's Avatar
 
Join Date: Nov 2003
Location: walla walla washington
Posts: 369
Likes: 0
Received 0 Likes on 0 Posts
i checked all my fuses and they are all good know what should i do?
Old 12-01-03, 07:26 PM
  #4  
Junior Member

 
lamboz1's Avatar
 
Join Date: Apr 2002
Location: chicago
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
check the relay, did u just install high intensity lights?
Old 12-01-03, 07:50 PM
  #5  
Kai
Rotorphile.

 
Kai's Avatar
 
Join Date: Mar 2002
Location: Richmond/NoVA
Posts: 1,296
Likes: 0
Received 0 Likes on 0 Posts
sounds like it's time to start picking through wires.

Check your light switch harness, the part that plugs into the back of the switch. If it was burned melted, you should replace it. Failed light switches have a nasty habit of taking the little subharness with it.

Then again, when my light switch failed it only took out my running lights (sides and tails) and the headlights were fine.

Try replacing the fuses, sometimes when they fail they still look OK.
Old 12-15-03, 01:11 AM
  #6  
Senior Member

Thread Starter
 
rx78788's Avatar
 
Join Date: Nov 2003
Location: walla walla washington
Posts: 369
Likes: 0
Received 0 Likes on 0 Posts
just woudering how do i check the harness.
if it is bad will i be able to tell just by looking at it or is there some kind of special thing that you half to do to test it. thanks
Old 12-15-03, 08:32 AM
  #7  
Rotary Enthusiast

 
Hot_Dog's Avatar
 
Join Date: Nov 2001
Location: Alexandria, VA
Posts: 1,308
Received 149 Likes on 123 Posts
I've had a similar problem with the headlights on my '90 GXL. This has been the first headlight electrical problem that I've had with this car since I bought it in December 1989. The problem started out gradually and then got worse. Initially, one headlight appeared dimmer than the other. After several nights like this, the other headlight would appear dimmer, and so on. After a couple months, the low beams went out completely, but the high beams still worked. Finally, one night I had no headlights at all. Fortunately for me, the fog lights worked fine while the hedalights were out. Last weekend, I went to troubleshoot this problem and found that the wiring harness at the headlight switch had melted at one connection, and the connectors for each headlight had also melted at the ground plug. I replaced the headlight switch, the harness section for the headlight switch, the pigtails at the headlights, and the headlight bulbs. The headlights now are working fine after doing that fix.

Hot_Dog
90 RX7 GXL
02 Acura RSX-S
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
4
06-26-16 10:21 AM
Sharkbait24
New Member RX-7 Technical
1
08-12-15 10:36 AM



Quick Reply: lights don't turn on



All times are GMT -5. The time now is 07:52 PM.