jetting question
#1
Full Member
Thread Starter
iTrader: (6)
Join Date: Jul 2007
Location: Lenoir City, TN
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
jetting question
I wanted to find out what people with the dellorto 48 dhla were using. My car is stockport, header back exhaust, one peice manifold. 5th/6th sleeves removed, ( manifold wont allow use). wanted to know where to start with jeting,air,etc.. so i dont have to go buy a bunch of stuff i dont need. also if someone could let me know of a place to buy parts, that would be great.
#2
Full Member
Thread Starter
iTrader: (6)
Join Date: Jul 2007
Location: Lenoir City, TN
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
anyone????? come on guys there are very few of us rx7 owners who believe that a carb is a good upgrade. it would be nice to recieve support. i have the carb but its jetted for the 12a. just need some pointers in the right direction.
#3
13B N/A POWA!
Join Date: Apr 2002
Location: Everywhere, WRLD
Posts: 1,013
Likes: 0
Received 0 Likes
on
0 Posts
hey man, I run a carb also (Mikuni 44mm jetted for a 13B) but there isn't much support on this side of the forums...but sadly lots of flame wars haha
your best bet is to ask over in the 1st gen section (there are 13B guys over there) as they have the most experience in it and are very helpful with this, i'm not sure how you have your ignition setup but check in on that too as you might find something nice in that too
Hope that helps you out some,
K
btw, got any pics of your setup i'm curious...
your best bet is to ask over in the 1st gen section (there are 13B guys over there) as they have the most experience in it and are very helpful with this, i'm not sure how you have your ignition setup but check in on that too as you might find something nice in that too
Hope that helps you out some,
K
btw, got any pics of your setup i'm curious...
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM