well i bought some new injectors and im in a doubt here. Is it really all that hard to change injectors yourself or do u guys suggest me to pay someone that knows how to?......or maybe even get a few pointers to help me out in the process so i can save a couple of bucks,, thanks in advance..

 

It's not that difficult. Just pop off the Upper Intake and there they are! 12mm wrench!

 

good to know , thanks man

 

just make sure you have new injector o-rings, some petroleum jelly, but basically you have to remove the upper intake manifold. disconnect everything that may remain. vac lines, sensor connections, tb line. OH YEAH if you have a fuel pump cut off switch run the car and hit the switch to get out as much fuel as you can out of the system. less waste fo fuel and less mess. loosen the fuel rail bolts and get prepaired for some fuel. lots of rags helps. before totally removing the fuel rail disconnect the injector plugs. then you can remove the fuel rail and genlty wiggle the injectors out. Take your new injectors and apply some vaseline or petroleum jelly to the o-ring, and the top of the injector. Gently push one side of the o- ring down followed by the next side. Try not to twist tear, rip or otherwise damage the o-ring. replace the injector back in its hole on the block. tighten the fuel rail so that it is snug, Replace the injector harness and reverse the order in which you took everything off. My thing is if you are upgrading to bigger injectors I hope you have some type of the controller to take the injectors down a few points.