fuel,spark and air?? Im getting power to my injectors but it wont start. Since the injectors are have the clips and are timed by the computer. How do you know what clip goes to what injector??

 

bumpity

 

i dont really follow your question...

to figure out which connector goes to which injector FOR CERTAIN you can backprobe the ecu pins and check for continuity at the connectors. you just have to have the factory manual so you know which is which. if thats to hard, then the harness itself should be shaped in a way that you can figure it out pretty easily too.

you can also get a noid light and hook it up to the connector to make sure that it is being pulsed. it will blink when it is. or you can use a stethescope/long screwdriver and listen for the clicking of the injector itself

good luck, you sure its and injector problem?

 

you label them before you take them off...