Ok I have a 88 10th anny. That I have just did a turbo swap on and put some 720cc injectors in. I thought that I had low inpedince injectors but come to find out after doing some searching I find out that I have high inpedence injectors. My question is were and what resistor do I put in to go from high to low inpedence injecotrs. I would greatly apperciate any help with this matter. Thanks in advance guys.

 

from what i understand you can use low impendence injectors on one that has high but have to put resistors in when doing it the other way.

 

radio shack 10 watt 10 ohm resistors

 

install one resistor per injector. doesn't matter which wire you hook it up to I think.....

 

How much do those 10ohm resisters cost.. i have the same issue..

 

and would it be easier then putting a resistor box from a 86 mazda..

 

OK I may have confused my self here. I am trying to run low inpedence injectors on a high inpedence motor. So I have to put the resitor in correct.

 

yes you have to put a resistor inline, doesnt matter which wire off the fuel injector....tehre are 2....and yes, get those resistors from radio shack, they are less htan 5 bucks i think. 10 watt. 10 ohm resistors

And if you have high imp and are going to low you use the resistors.

 

Thanks for all the help guys. I am hoping that this will fix my fuel problem.

 

I would suggest you put the radio shack resistors in at the ecu because those resistors are not ment for the heat. If you want to put them in at the engine then get the resistors from rx7.com

https://www.rx7club.com/showthread.p...=put+resistors