Idle is around 2K???
#2
ok, you have the tps adjusted...have you adjusted the idle after you adjusted the tps? if you haven't recheck that...and also, do you have the tb mod? if you do make sure the thermo wax sensor is off...when i did the mod, i got lazy and left it on there and my idle was at 1.5k until i took it off...one last thing...check your throttle cable...
#3
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Katy Tx. 77084
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
its got to do with my throttle adjustment, when i pull up on the pedal, it drops to 750, also disconnected the air supply valve, since there isn't any ps in my car anymore...
next, up tackle the heat!!!
elec fan, new stat, and full coolant flush!!!
next, up tackle the heat!!!
elec fan, new stat, and full coolant flush!!!
#4
if that's the case, definitely check the cable...it's probably on there too tight...loosen the 2 nuts holding it in place on the tb. the cable should have a little bit of slack...
#5
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Katy Tx. 77084
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
hey thanks alot!!!
ill check that thermo wax thing out, i do have the tb mod, just did it... and yes it idles about 1.5k and stays when i hit the gas, but when i pull on the pedal it drops down, so i'm thinking its the throttle too tight....
thanks
rocky
ill check that thermo wax thing out, i do have the tb mod, just did it... and yes it idles about 1.5k and stays when i hit the gas, but when i pull on the pedal it drops down, so i'm thinking its the throttle too tight....
thanks
rocky
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM