I think my coolant temp sensor is jacked or something?
#1
Full Member
Thread Starter
Join Date: Jun 2003
Location: denver
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
I think my coolant temp sensor is jacked or something?
ok i was looking in the haynes manual and noticed that i have this wire coming out from the block. Its right to the side, little below the oil filter(if you were looking at the car from the drivers side fender). WTH is this, my coolant temp sensor? Im in the middle of replacing my entire harness right now(dont ask long shity story lol) but im just wondering because this could end up being bad later on. If anyone has any pics that would be great
__________________
__________________
#4
Rotary Enthusiast
Join Date: Oct 2003
Location: Wichita, KS
Posts: 1,183
Likes: 0
Received 0 Likes
on
0 Posts
yes, there's a wire that plugs into a coolant temp sensor on teh driver side of the engine a little below the oil filter and right next to the oil pressure sender. The only thing that does is give a reading to your coolant temp gauge in your gauge cluster. So without it, you will not see the coolant temps on your gauge. That's all it does.
Trending Topics
#8
wtf's a piston
Join Date: Mar 2004
Location: Englewood, FL
Posts: 1,717
Likes: 0
Received 0 Likes
on
0 Posts
quick thread hijack, the sensor on the back of the waterpump housing, one is that green rectangle plug, what is the other one bout 2"s to the right, it's an octagon, bout 1" dia and theres two seperate wires coming out of it that go into one plug that looks like the TPS plug. It's also on the waterpump housing. Its and s4 jdm engine.
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM