is there n e way i can rig my heater to heat and defrost with a toggle????

 

english next time.

and no

 

y not ???

 

because you don't know how to type English.

 

The air mix motor and mode motors work off two wire reversing polarity. So (granted your English skills make it hard to make out what you really are asking), I am assuming you are asking if you can use a toggle switch to wire to the motors.

Well to reverse the polarity you could use a dual make mom/off/mom toggle switch (for each function) but then you don't have any way to determine where the motor position is. So you hold the toggle 5 seconds too long and your burn the motor out.

Of course then you would have to replace the motor before installing a Logicon back into the car... and the easiest way to replace the air mix and mode motors is to remove the entire dash board assembly...

Then toss in the fact that you think a simple 3 letter word like "why" is spelled like Y... well it pretty much says if you can't type the extra two letters to be clear, you probably won't be able to even figure out how to take the Logicon out...

So that is why I said no

 

well sorry for the laziness but i already have the old one out and abviously i am going to need to track down a new one but thanks for the insite any way