I have a question about wiring harnesses.
09-12-06, 07:27 PM
#1
Non-op
Thread Starter
iTrader: (2)
Join Date: Jul 2005
Location: San francisco
Posts: 462
Likes: 0
Received 0 Likes
on
0 Posts
I have a question about wiring harnesses.
I have a jdm wiring harness and i would like to know if it is possible to use it with an american rx7. i bought the engine from a jdm inporter.
If it is not possible to use with my rx7 then is there any mods i can do to get it to work.
let me know. i dont wnat to feel moded when i try to install the engine and it doesnt work
If it is not possible to use with my rx7 then is there any mods i can do to get it to work.
let me know. i dont wnat to feel moded when i try to install the engine and it doesnt work
09-12-06, 08:14 PM
#2
Full Member
Join Date: Dec 2004
Location: 310
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
You Will Not Be Able To Use It In An American Car. The Crank Angle Sensor Is On The Jdm Harness, In The Us It Is In The Drivers Side Harness. The Fit Wont Quite Reach And Will Most Likely Tear. Im Not Sure If You Can Modify It To Fit,
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
