2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

HP estimate

Thread Tools
 
Search this Thread
 
Old Jun 6, 2004 | 06:07 PM
  #1  
eddierotary's Avatar
Thread Starter
back with rotaries
Tenured Member 20 Years
iTrader: (7)
 
Joined: Nov 2001
Posts: 2,239
Likes: 1
From: Watertown, NY
HP estimate

ok i need some opinions of what HP im making. i have a S4 turbo II engine that is been street ported both intake and exhaust and have hurley apex seals, turbo is a S5 non ported boosting betwen 10-12 psi for now, NPR intercooler with 2.5 inch intercooler pipes, exhaust is a 2.5 RB down pipe with magnaflow muffler as a presilencer and megan racing fart cannon (N1 imitation muffler for those doesnt know) MSD coils and stock FB dizzy. microtech LT-4 ecu(still tuning her) with 550 primary and 680 sec and stock gslse fuel pump(later on ill gonna put a walbro pump) 3 inch intake with a K&N filter. stock numbers NGK spark plugs of sen gens. E fan, still have PS but the pulley for the AC is rermoved. that all i can thik of right now so about how much HP i have? could i make over 250hp? thanks

eddie
Reply
Old Jun 6, 2004 | 06:20 PM
  #2  
fstrnyou's Avatar
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Sep 2002
Posts: 1,233
Likes: 0
From: Statesboro, GA
well, you might want to replace that fuel pump sooner than you had anticipated. Assuming that you are probably making 250hp+, most TIIers would have replaced the stock TII pump by this time. I'm pretty sure that the GSLSE pump flow rates are miniscule compared to the stock TII pump.
Reply
Old Jun 6, 2004 | 06:40 PM
  #3  
eddierotary's Avatar
Thread Starter
back with rotaries
Tenured Member 20 Years
iTrader: (7)
 
Joined: Nov 2001
Posts: 2,239
Likes: 1
From: Watertown, NY
well from what i heard the gslse fuel pump flows a little more that the turbo II ones, i know a couple of people that use them with the same setup and they havent lean out yet, i will gonna replace my SE pump eventually because i have plans for it soon, im not hogging on it. im been easy on the car because i dont wanna break her too quick
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
MODRIFT7
Old School and Other Rotary
1
Sep 22, 2015 12:14 PM
Mrmatt3465
Interior / Exterior / Audio
8
Sep 17, 2015 01:28 PM
mulcryant
2nd Generation Specific (1986-1992)
10
Sep 9, 2015 05:24 PM
Snook
3rd Generation Specific (1993-2002)
180
Sep 6, 2015 12:50 PM




All times are GMT -5. The time now is 04:16 AM.