How To Vent Oil Filler/Crankcase After Emissions Removal?
Thread Starter
Junior Member
Joined: Nov 2006
Posts: 37
Likes: 0
From: oklahoma
How To Vent Oil Filler/Crankcase After Emissions Removal?
took off all emissions and all that crap. i searched but couldnt find how to properly vent the tube coming off the oil filler. and ideas and pics possibly?
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
"Proper" will depend on opinion.
In my opinion, the proper way is to keep the stock purge system in tact. In that case, the lower nipple on the middle iron gets connected to filtered fresh air, the upper nipple on the filler tube gets connected to the large nipple on the purge valve. The bottom unused nipple on the purge valve then gets connected to an nipple before the throttle plates, and the top to a vacuum source.
Or you can be lame and use a catch-can setup like most people do.
In my opinion, the proper way is to keep the stock purge system in tact. In that case, the lower nipple on the middle iron gets connected to filtered fresh air, the upper nipple on the filler tube gets connected to the large nipple on the purge valve. The bottom unused nipple on the purge valve then gets connected to an nipple before the throttle plates, and the top to a vacuum source.
Or you can be lame and use a catch-can setup like most people do.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
