how to tap a line into the acessory on wiring?
Thread Starter
I "lost" my emissions....
Joined: Apr 2005
Posts: 1,764
Likes: 6
From: lillington, nc
how to tap a line into the acessory on wiring?
if i wanted to install fog lights, but want my car to beep when its off but they are on, like it does with headlights, how do i do that?
The factory service manual wiring diagrams are going to be your friend here. I'm not sure what the warning beeper ties into, but I suspect it's one of the outputs off the headlight switch.
I know turning my headlights on with the DRL switch (aftermarket addition) doesn't turn the beeper on, so I make a point of turning the running lights on as well to warn me (I've drained the battery more than once).
If I have some time tonight, I'll dig into the FSM and see what I can find.
-=Russ=-
I know turning my headlights on with the DRL switch (aftermarket addition) doesn't turn the beeper on, so I make a point of turning the running lights on as well to warn me (I've drained the battery more than once).
If I have some time tonight, I'll dig into the FSM and see what I can find.
-=Russ=-
You would just tap a wire off of your fog light relay's output to the fog lights, to the CPU's light input wire, and use two diodes to isolate the two wires as they feed into the CPU
Note Dreyko:
You may wish to read my explanation of wiring up fog lights in this thread, as it sounds like you may have questionable wiring
https://www.rx7club.com/showthread.p...81#post5042681
Note Dreyko:
You may wish to read my explanation of wiring up fog lights in this thread, as it sounds like you may have questionable wiring
https://www.rx7club.com/showthread.p...81#post5042681
Last edited by Icemark; Dec 1, 2005 at 05:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
Aug 22, 2015 05:52 PM
Rx7_brad
3rd Generation Specific (1993-2002)
0
Aug 15, 2015 09:57 AM




