how to set the brapaping idle brigde port use haltech elite
05-20-18, 11:19 AM
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Feb 2013
Location: Indonesia
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
how to set the brapaping idle brigde port use haltech elite
hi im Henry now i tue my customer engine. rx7 13b rew s8. i port the bridge port use pinnaple racing templetes. but the idle is no braaping and in the first start is so rich (before ported is in normal smooth idle). i use drive by wire throttle from rx8, ecu comes from haltech elite 2500, coil packs from aem smart coil. us single turbo from owen development gbt6988 ar0.82.
can anyone help me about the braaping idle?
can anyone help me about the braaping idle?
06-04-18, 12:08 AM
#2
Well this thread is a bit old, but there is a specific sub-forum for Haltech EMS, you'll have better luck asking someone there.
https://www.rx7club.com/haltech-forum-62/
https://www.rx7club.com/haltech-forum-62/
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Engine Management Forum
25
10-22-20 08:32 AM
wreckerx7
1st Generation Specific (1979-1985)
57
09-17-18 10:55 AM
XBLADE
2nd Generation Specific (1986-1992)
6
04-05-18 02:45 PM
