How much fuel do i need?
08-28-02, 05:58 PM
#1
Rotary Enthusiast
Thread Starter
Join Date: Apr 2001
Location: Mississauga
Posts: 974
Likes: 0
Received 0 Likes
on
0 Posts
How much fuel do i need?
Im going to be running the following NA setup soon:
Rx-7 specialties motor -
FD rotor housings
TII intermidiate housing
S5 NA rotors
NA endplates
I think this motor will be streetported also
2.5" straight thru single exhaust with RB header
k&n filter, cold air box, hood scoop.
No emissions, efan, no PS, no AC.
My question to all you gurus out there is, how much fuel do i need for this? Just a new pump (FD?) or injectors and SAFC?
Also what powere am i expecting? i was told 190hp.
Thanks,
Jakob
Rx-7 specialties motor -
FD rotor housings
TII intermidiate housing
S5 NA rotors
NA endplates
I think this motor will be streetported also
2.5" straight thru single exhaust with RB header
k&n filter, cold air box, hood scoop.
No emissions, efan, no PS, no AC.
My question to all you gurus out there is, how much fuel do i need for this? Just a new pump (FD?) or injectors and SAFC?
Also what powere am i expecting? i was told 190hp.
Thanks,
Jakob
08-29-02, 10:14 AM
#4
I don't think NA's need to worry too much about running lean. TII pump is more than enough.
You should still invest in the S-AFC. It will allow you to lean out your idle and adjust your fuel for that little bit of extra performance.
While you're at it. Remove the OMP and **** and run pre-mix!!!! DO IT!
You should still invest in the S-AFC. It will allow you to lean out your idle and adjust your fuel for that little bit of extra performance.
While you're at it. Remove the OMP and **** and run pre-mix!!!! DO IT!
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM