How to get through firewall?
Passenger
Posts: n/a
How to get through firewall?
Heres my prob. I just bought a perma-cool fan, now I need to hook it up.
I bought a manual switch for it and I want to put it where my security light thing is behind the shifter. So I need to run the wires from the fan to the switch. What would be the best way to do this?
Thanks in advance -
I bought a manual switch for it and I want to put it where my security light thing is behind the shifter. So I need to run the wires from the fan to the switch. What would be the best way to do this?
Thanks in advance -
Joined: Apr 2002
Posts: 4,232
Likes: 0
From: Rotaryland, New Hampshire
just run it under the shift boot trim piece up under the dash over teh the hole where the dash wiring goes though teh firewall and run it out there, wont be tacky at all
Joined: Aug 2001
Posts: 6,096
Likes: 9
From: So Cal where the OC/LA/SB counties meet
My suggestion
Run the wires through the drivers side (thus cooler side) of the engine bay to just below the Clutch Master Cylinder. There you'll find where the Main Wire Harness goes through the firewall.
If you make a small hole in middle top of the harness's rubber plug, you're wires should snake through easily and without much obstruction. Bonus is your wires will have the rubber protection from grounding to the firewall.
If you make a small hole in middle top of the harness's rubber plug, you're wires should snake through easily and without much obstruction. Bonus is your wires will have the rubber protection from grounding to the firewall.
Thread
Thread Starter
Forum
Replies
Last Post
scissorhands
New Member RX-7 Technical
0
Sep 16, 2015 01:25 PM