How do you guys get the bearing races out of TII hubs?
#1
How do you guys get the bearing races out of TII front hubs?
Hey guys,
I'm in the process of doing a 5 lug conversion on my widebody FB, and bought new inner bearings and races. Only problem is I can't see how to get the races out.
There doesn't seem to be a lip of any sort built into the hub to all you to get the race out, and the race sits flush in there so you can't really contact it with anything. I do have access to a hydraulic press, but I can't see how it would even be possible to get the press to push out the race.
All suggestions are appreciated!
Thanks
Dan_s_young
I'm in the process of doing a 5 lug conversion on my widebody FB, and bought new inner bearings and races. Only problem is I can't see how to get the races out.
There doesn't seem to be a lip of any sort built into the hub to all you to get the race out, and the race sits flush in there so you can't really contact it with anything. I do have access to a hydraulic press, but I can't see how it would even be possible to get the press to push out the race.
All suggestions are appreciated!
Thanks
Dan_s_young
Last edited by Dan_s_young; 09-03-06 at 01:23 PM.
#2
Junior Member
Join Date: Feb 2005
Location: ponca city, OK
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
this is what I did http://www.mazdatrix.com/faq/frontbrg.htm
Thread
Thread Starter
Forum
Replies
Last Post
tallbozo
1st Generation Specific (1979-1985)
3
08-15-15 02:47 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM