REAmemiya_fan

So after taking off my front wheels and brakes with the calipers to machine (lathe) my rotors to a newly usable level, i re-packed my bearings and now have to put them back in. What is the proper way of approaching this? (assuming that i mayyyyy have already put it back on without thinking about it...)

REAmemiya_fan

More specifically i need to know the pre-load and all those specific goodies.

clokker

iTrader: (2)

FSM here!

Turbonut

iTrader: (1)

Good rule of thumb, tighten down until the washer behind the spindle nut can't be moved back and forth, then back off until it is moveable once again. I use a screwdriver inside the hub, just **** the screwdrver and move the washer, tighten slightly, then go to the other side and do the same and continue until the above is satisfied.