How cheaply can I do a good rebuild for?
12-17-04, 06:05 PM
#1
How cheaply can I do a good rebuild for?
so I've blown up YET ANOTHER motor.....
I've got 2 blown s5 jspecs in my garage... both should have good housings but I know at least that between the two I'll have enough parts to build one decent motor.
How much $$$ to build one, on a budget?
I've got 2 blown s5 jspecs in my garage... both should have good housings but I know at least that between the two I'll have enough parts to build one decent motor.
How much $$$ to build one, on a budget?
12-17-04, 06:43 PM
#2
Rotary Enthusiast
iTrader: (9)
Join Date: Jun 2003
Location: west
Posts: 1,191
Likes: 0
Received 0 Likes
on
0 Posts
If everything is ok, you'll just need a gasket set. Try Atkins Rotary.
The last time I checked it was about $320. for turbo gasket
They had the best prices and have never failed to deliver what I need. And I live in the middle of the Pacific. When you take it apart you should mic the housings if it is within spec. How did you blow the 2 motors??
Also, invest in some Hylomar sealant for all the O-rings.
The last time I checked it was about $320. for turbo gasket
They had the best prices and have never failed to deliver what I need. And I live in the middle of the Pacific. When you take it apart you should mic the housings if it is within spec. How did you blow the 2 motors??
Also, invest in some Hylomar sealant for all the O-rings.
Last edited by boosted1205; 12-17-04 at 06:46 PM.
Thread
Thread Starter
Forum
Replies
Last Post