how can u tell if u've hit boost cut?!?
Thread Starter
Junior Member
Joined: Dec 2003
Posts: 11
Likes: 0
From: Australia, sydney
how can u tell if u've hit boost cut?!?
heyz guyz,
i have an rx7 series 4 import turbo. ive done some small modz which are
an exhaust system full from turbo baq. its a 3.5" to a 3" dual. (had a 4" but people said it was too big so i changed it) and a POD filter with a full CAI. 1st & 2nd gear is fine..i can rev it out to 7 without feeling the boost cut feeling. but in 3rd..at 6000+rpm the car cuts out n revs again then cuts out then revs again. its happens in 4th and 5th.
is this the boost cut that comes standard?...or is it something else.
plz help guyz. im new to the turbo and rotor world so i dont know much.
thanks.
i have an rx7 series 4 import turbo. ive done some small modz which are
an exhaust system full from turbo baq. its a 3.5" to a 3" dual. (had a 4" but people said it was too big so i changed it) and a POD filter with a full CAI. 1st & 2nd gear is fine..i can rev it out to 7 without feeling the boost cut feeling. but in 3rd..at 6000+rpm the car cuts out n revs again then cuts out then revs again. its happens in 4th and 5th.
is this the boost cut that comes standard?...or is it something else.
plz help guyz. im new to the turbo and rotor world so i dont know much.
thanks.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
Mar 15, 2022 12:04 PM
troym55
3rd Generation Specific (1993-2002)
23
May 25, 2016 12:42 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
AXA
Single Turbo RX-7's
8
Sep 5, 2015 10:06 AM
