horn wont stop
#1
Junior Member
Thread Starter
Join Date: Jul 2006
Location: Massachusetts
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
horn wont stop
after about 2 minutes of turning the car on the horn goes off and i cant stop it unless i take out the circut board, which also dissables the use of the horn and the dash lights. is there anything i can do to fix this?
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
Assuming that you don't have a theft protection problem.................
Remove the plug from the CPU. With your meter make sure there is no gnd on the Green/Orange wire. When you honk the horn all you do is put a gnd on that wire. So make sure it is not grounded. IF grounded, then you have a problem towards the horn buttons.
No ground? Then it seems it would be a horn relay problem in the CPU.
If my horn was honking and I did not want to hear it, I'd pull the wires off the horns themselves til I fixed the problem. Sure wouldn't pull the CPU plug off.
Remove the plug from the CPU. With your meter make sure there is no gnd on the Green/Orange wire. When you honk the horn all you do is put a gnd on that wire. So make sure it is not grounded. IF grounded, then you have a problem towards the horn buttons.
No ground? Then it seems it would be a horn relay problem in the CPU.
If my horn was honking and I did not want to hear it, I'd pull the wires off the horns themselves til I fixed the problem. Sure wouldn't pull the CPU plug off.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM