hood latch
#1
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
hood latch
ok so i guess im a bit fat but i havent tried to close my hood since i pulled my motor and now i am doing my intercooler setup and i needed to see if my hood will clear. but anyway im guessing the hood latch support bent from me leaning on it. Any ideas on how to fix this? i think the whole mess is just pressed down.
#2
Winter sucks
Join Date: Jan 2004
Location: Newberg, Oregon
Posts: 3,083
Likes: 0
Received 0 Likes
on
0 Posts
ok so i guess im a bit fat but i havent tried to close my hood since i pulled my motor and now i am doing my intercooler setup and i needed to see if my hood will clear. but anyway im guessing the hood latch support bent from me leaning on it. Any ideas on how to fix this? i think the whole mess is just pressed down.
a friend of mine jumped on the hood of my last 7 and did the same **** to mine... except he broke the bolt in the front of it that holds it to the bracket. Bend what you can back and it should be fine as long as nothing "broke".
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM