He everyone. First off, I have spent a good couple hours searching the board and the internet in general and have had no luck.

I'll admit I am pretty stupid, but its the first time I've pulled the motor from my rx7. I have an 89 GTU that I got a rebuilt engine for. With the help of my neighbor, the engine is in and most of the hard work is done.

The trouble I'm running into is the wiring. I have the Hayne's Manual and downloaded the service manual from fc3s.org, as well as looked around the site here. I'm trying to get the wiring harness back in and everything hooked up, ideally to get it started very soon, but am having trouble remembering how exactly to run the harness through everything and where some wires need to go.

If anyone has some detailed pictures or a diagram showing how this needs to be, it would be a huge help. In my searches, I have seen a few things for the TII, but they didn't help me out that much.

Thanks in advance, sorry if this post is too long

 

Cant really help, it's all plug and play pretty much. Can you remember basiclly how it came apart? Put it back that way. You might have to take a couple attampts at it before getting it right.

 

Thanks. I'll give it another shot. That stuff is pulled pretty tight, i just figured that somebody would have a picture or something.

 

Good Luck

 

Right series of engine for the right series of car?