2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

HELP- Were is fuel pump fues

Old Jan 12, 2008 | 05:46 PM
  #1  
fc3sdude's Avatar
Thread Starter
tHaToNeGuY
 
Joined: Jun 2007
Posts: 209
Likes: 0
From: Casper, Wy
HELP- Were is fuel pump fues

I need to find out were my fuel pump fuse it thanks.
Reply
Old Jan 12, 2008 | 06:14 PM
  #2  
NZConvertible's Avatar
I'm a boost creep...
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
Why? If we know what the whole problem is we can give you a whole solution.

The fuel pump is fed from the ENGINE fuse in the interior engine box. If it's blown the engine won't run because the EFI system won't have power either.

If you're checking for power at the fuel pump, it won't get any unless the engine is cranking or running.

More info would be good...
Reply
Old Jan 12, 2008 | 07:39 PM
  #3  
fc3sdude's Avatar
Thread Starter
tHaToNeGuY
 
Joined: Jun 2007
Posts: 209
Likes: 0
From: Casper, Wy
I was wanting to know so that i could take it out and deflood my car. Like shut of the fuel pump take the spark plugs out and crank the motor but its cool i found it.
Reply
Old Jan 12, 2008 | 08:10 PM
  #4  
NZConvertible's Avatar
I'm a boost creep...
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
Pulling the EGI fuse in the engine bay is easier. Even better is installing a fuel pump switch.

This pic shows the Circuit Opening Relay that turns off the fuel pump if the engine stalls. It’s a located under the dash next to the steering column and has a yellow base.

The B wire (black with a white stripe) is the power supply and the Fp wire (blue with a red stripe) goes to the fuel pump. The switch can go into either of these wires, it doesn’t matter which. Simply cut the wire, extend each cut end to your chosen switch location using the same or thicker gauge wire and terminate them onto the switch. Note that the STA wire is also black with a white stripe, but it’s thinner. Make sure you get the right wire.

See? More info = better answer!

Last edited by NZConvertible; Jan 12, 2008 at 08:17 PM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Rotospectre
New Member RX-7 Technical
3
Mar 28, 2018 03:33 PM
ChrisRX8PR
Single Turbo RX-7's
21
Oct 18, 2015 04:01 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 05:12 PM.