help! timing! underdrive pulley question
#1
help! timing! underdrive pulley question
I just bought the 74-92 Underdrive Eccentric Pulley 4" OD
Timing marks at -10 (ATDC) 0, 10 (BTDC) and 20 (BTDC)
from mazdatrix.com
my 87 is wayy out of time and I wanted to know what timing mark I should put it on.
I'm also not sure which timing mark is which.
here is the pic and I used paint with 4 colors, green, blue, red, yellow to mark them. I know how to set the cas but please help me with this.
Timing marks at -10 (ATDC) 0, 10 (BTDC) and 20 (BTDC)
from mazdatrix.com
my 87 is wayy out of time and I wanted to know what timing mark I should put it on.
I'm also not sure which timing mark is which.
here is the pic and I used paint with 4 colors, green, blue, red, yellow to mark them. I know how to set the cas but please help me with this.
#2
When I did mine I put it at zero by hand then lined up the gear marks on the crank angel sensor put it in place and set the timeing from there. note had to reset the marks on the crank angle sensor twice as they tend to move on you while reinstalling. third time was the chare i guess since went together perfect and needed almost no correction.
#3
it's to late tonight the people across the street will call the cops on me ^_^ but first thing tomorrow morning I am gonna go for it.
I flood cleared it tonight using the super flood clear method (did it 4 times)
thx for the info
if anyone else has a different story tell me what you did.
I flood cleared it tonight using the super flood clear method (did it 4 times)
thx for the info
if anyone else has a different story tell me what you did.
#5
http://www.mazdatrix.com/b9.htm
http://www.mazdatrix.com/getprice.asp?partnum=11469
$65 and whatever shipping was
http://www.mazdatrix.com/getprice.asp?partnum=11469
$65 and whatever shipping was
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
LunchboxCritter
2nd Generation Specific (1986-1992)
15
01-03-16 04:11 PM
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM